Kodak 7520 manual Controlled power- down sequence

Controlled power- down sequence

Before performing the controlled power-down sequence, determine if the error can be addressed from the host. If so, perform the required host recovery procedures. If the error cannot be addressed from the host, or if the scanner’s error message cannot be cleared when the host recovery procedures are performed, continue with the following power-down sequence.

1.Wait for all information currently held in the buffer to be transferred to the host system.

2.If necessary, prepare the host and corresponding system components for a scanner power-down, per host system instructions.

3.Turn off the scanner power for at least 5 seconds, then turn the power back on again.

4.If necessary, determine the last image transferred to the host, reset the image address and image level to the correct values, and rescan all documents whose images have not been transferred to the host.

5.If required, calibrate the scanner before rescanning.

6.If the error condition is not cleared using the controlled power-down sequence, contact Service.

6-2 A-61140 January 2000