2 Getting Started
Turning on the scanner
The following steps are necessary to prepare the scanner for operation. Procedures on how to perform these steps are described in this chapter.
1.Turn on the power to the scanner.
2.Select the language display.
3.Calibrate the scanner.
4.Prepare the documents for scanning.
5.Adjust the feed and separator roller gap, if required
6.Adjust the feed shelf position.
7.Adjust the feed shelf side guides.
8.Adjust the exit hopper side guides and end stop.
9.Select the desired application mode and image level, or the Count Only function.
10.Start the scanner from the host computer. (This step is not necessary for the Count Only function.)
11.Press Run.
12.Feed the documents into the scanner.
13.Press Stop or End, depending on whether the batch or job has been completed.
NOTE: After you press Stop, Run can be pressed again and more documents can be fed into the scanner. After pressing End, you must enable the scanner from the host computer before scanning again.
Follow the steps below to turn on the power to the scanner.
1.Turn on the power switch (located at the rear of the machine).
NOTE: Several initialization messages will appear in the status display. If you cannot see any messages, try adjusting the contrast.
2.Send the Scan command from the host computer to the scanner. The message Enabled will appear in the status display. The current application mode and next image address will also be displayed.
IMPORTANT: Do not use the operating keys until the Warming Up Completed message has been displayed. Entries made before this message is displayed will not be recognized by the scanner.
