Kodak 7520 manual Dry the imaging guides with a dry, lint-free cloth

4.Release and remove the rear imaging guide by swinging the guide toward the front of the scanner (to release it from the two magnets), and lifting it from the scanner’s two mounting pins.

5.Clean the surfaces of both the front and rear imaging guides with an antistatic wiper or a clean, soft, lint-free cloth, slightly moistened with water or lens cleaner.

6.Dry the imaging guides with a dry, lint-free cloth.

7.Hold the rear imaging guide by the edges and carefully set it back into the scanner by seating it on the mounting pins. Swing the guide toward the rear of the scanner to fix it to the two magnets.

NOTE: Look through the upper access door and side access door to make sure the imaging guide is mounted correctly. There are two sets of pins. Make sure the guide is seated on the small, lower set of pins. When the rear imaging guide is seated correctly, the top of the guide will sit approximately a ½-inch (10 mm) from the vertical transport plate. The rear imaging guide will become flush with the plate when the plate is closed.

Rear imaging guide saddle mount

Rear imaging guide mounting pin

8.Hold the front imaging guide by the edges and carefully set it back into the scanner by seating the guide’s two green saddle mounts on to the mounting shaft, and rotating the front imaging guide thumbscrew 90° clockwise.

NOTE: Look through the upper access door and side access door to make sure the imaging guide is mounted correctly. The bottom of the front imaging guide must be seated just inside the vertical transport plate. The front imaging guide could be damaged if it is seated incorrectly when the vertical transport plate is closed.

Front imaging guide saddle mount

Vertical transport plate

A-61140 January 2000 5-3