Kodak 7520 manual

5.Grasp and hold the new lower imaging guide by the green handle and carefully slide it into place. Make sure the grooves fully engage the track.

Rear imaging guide saddle mount

Rear imaging guide mounting pin

6.Hold the new front imaging guide by the edges and carefully set it back into the scanner by seating the guide’s two green saddle mounts on to the mounting shaft, and rotating the front imaging guide thumbscrew 90° clockwise.

NOTE: The imaging guides are not interchangeable. They can only be inserted one way.

Look through the upper access door and side access door to make sure the imaging guide is mounted correctly. There are two sets of pins. Make sure the guide is seated on the small, lower set of pins. When the rear imaging guide is seated correctly, the top of the guide will sit approximately a ½-inch (10 mm) from the vertical transport plate. The rear imaging guide will become flush with the plate when the plate is closed.

Front imaging guide saddle mount

Vertical transport plate

5-18 A-61140 January 1999