Eaton Electrical I.B. 29C892B SECTION 2: HARDWARE DESCRIPTION

I.B. 29C892B Page 3

SECTION 2: HARDWARE DESCRIPTION

CAUTION

2-1 GENERAL

The purpose of this section is to familiarize the reader with OPTIMizer hardware, its nomenclature, and any applicable specifications. The information presented is divided into the following three sections:

•Package and External Connections

•Operator Panel

•Specification Summary

Notice: Integral to the OPTIMizer Hand Held Programmer is the ability to lock out changes to a breaker’s settings through the use of a pass- word. The correct password must be entered to proceed with setpoint changes, baud rate changes or the initiation of a test. The password entry field contains four digits that can be changed. The factory installed password 1000 can be used until a new password is selected by the user.

THIS IS A SOPHISTICATED PIECE OF ELECTRICAL EQUIPMENT. AS SUCH, IT SHOULD BE HANDLED CAREFULLY AT ALL TIMES TO AVOID POSSIBLE DEVICE DAMAGE.

2-2 PACKAGE AND EXTERNAL CONNECTIONS

The OPTIMizer Hand Held Programmer is packaged in a high strength plastic housing with approximate dimensions of 5.75 inches by 3.5 inches by 1.25 inches. An operator panel with a display and associated pushbuttons are located on the front of the device (Figure 2-1). External connections are made on the top of the hand held programmer (Figure 2-2). A top hinged protective cover is provided to protect external connections from the entrance of foreign matter. The protective cover is opened through the use of a thumb nail notch (Figure 2- 3). A storage case holds the hand held programmer and its phone type connection cord.

			1
				1	On/Off Pushbutton
				2	Save Pushbutton
		8		3	Select Pushbutton
				4	View Functions
					Up-Arrow Pushbutton
				5	Right-Arrow
7					Pushbutton
	4			6	Left-Arrow
					Pushbutton
				7	Edit Values Up and
	6	5			Down Pushbuttons
			2	8	Liquid Crystal Display
	3
7

Figure 2-1 OPTIMizer Operator Panel

Effective 8/99