8

ASSEMBLY

POWER HEAD SHAFT/LOWER SHAFT ASSEMBLY

Tools Required: None

Parts Required: PAS or SRM-SB Power Head w/Shaft & Coupling.

1.Set Power Head/Shaft Assembly on a level surface.

2.Pull locator pin (A) out, and turn counter-clockwise 1/4 turn to lock- out position.

3.Remove vinyl cap from attachment drive shaft.

4.Carefully fit attachment drive shaft assembly into coupler (B) to decal assembly line (C), making sure that the inner lower drive shaft engages into the square upper drive shaft socket.

NOTE

Earlier model Power Heads may have shorter couplings. Short couplings fit flush to decal point (E). New couplings are 4-3/4 in. long, and fit flush to line (C).

5.Rotate locator pin (A) 1/4 turn clockwise to engage lower shaft hole. Insure locator pin is fully engaged by twisting lower drive shaft. Locator pin should snap flush in coupler. Full engagement will prevent further shaft rotation.

6.Secure lower shaft assembly to coupler by tightening clamping knob (D).

B

D

E

C

A

D

C

A