POWER BLOWER 15

OPERATOR'S MANUAL

WARNING DANGER

Allow the engine and muffler to completely cool before performing any maintenance activity.

AIR FILTERLevel1.

Tools required: 25 - 50mm (1 - 2 in.) cleaning brush

Parts required: Tune Up Kit P/N 90071C

NOTE

Always brush dirt and debris away from air cleaner area prior to cleaning air filter.

1.Brush dirt off air cleaner area. Keep dirt away from engine and air intake grid.

2.Remove air filter cover. Brush dirt from inside cover and away from edges of air filter.

3.Check air filter seal for tight fit with air filter case.

4.Remove air filter from case. Use care to prevent dirt and debris from falling into air filter case.

5.Inspect filter element and seal. Replace filter if any of these problems are present:

•Air filter seal does not fit tightly against case •Air filter seal is distorted, worn, or damaged •Air filter element has holes or other damage •Air filter element is saturated with dirt

•Air filter element is soaked with fuel mix

6.If air filter is in good condition and can be cleaned and reused, lightly brush debris from air filter element, or blow filter element clean using low pressure (40 psi or less) compressed air directed at inside of filter.

IMPORTANT

When using compressed air, always direct air stream at inside surface of filter so dust and debris will be blown out of filter. Keep air nozzle 6 - 8 inches away from filter to prevent damage to filter.

7.Install air filter in case, and replace cover.

NOTICE

Actual replacement interval for air filter depends on operating conditions. Operation in dustier applications requires more frequent cleaning and replacement. Continued operation with a damaged or excessively dirty filter will allow dirt and debris to enter engine, and result in poor performance, rapid engine wear, and premature engine failure.