ASSEMBLY |
ASSEMBLY
Drive Shaft/Power Head
Parts Required: | Power Head, Drive Shaft Assembly |
1.Stand power head upright on a level surface.
2.Loosen the drive shaft clamp bolt (A) at engine drive shaft clamp.
3.Remove dust cap if necessary, and carefully fit drive shaft assembly to engine making sure that inner drive shaft engages into clutch mount.
Note: Gear Housing must be aligned properly with engine.
4.Tighten drive shaft clamp bolt (A) securely.
5.Route throttle linkage and ignition lead assembly below fan housing.
Throttle Linkage and Ignition Leads
1.Close choke and remove air filter cover.
2.Place throttle linkage (C) through adjustment fixture (D) and install wire end into large carburetor throttle swivel hole (E). Check throttle for freedom of movement and that wide open throttle / low idle extremes are adjusted properly. The throttle linkage must be adjusted by moving the adjustment fixture (D). Consult with your Echo Dealer for correct adjustment procedure.
3.Connect 2 ignition stop leads (F, G) from throttle cable tubing to 2 ignition leads (F, G) on engine.
IA
C
E
D
G
F
X7502026303 | 13 |
© 6/2014 ECHO Inc.
