Power PrunerTM 15

Operator's Manual

lubricating the guide bar and saw chain

Automatic Oiling System

1.Wipe debris from around oil fill cap.

2.Remove oil fill cap and fill reservoir with a quality, low viscosity guide bar and saw chain oil.

NOTE

The discharge volume of the automatic oiler is preset to deliver 3 to 4 cc/min. at normal operating RPM. During heavy or dry cutting conditions the oil discharge volume may be adjusted to assure adequate lubrication. Refill the oil reservoir with each tank of fuel.

IMPORTANT

To prevent plastic deterioration, do not use synthetic or silicone based oil.

adjusting automatic oiler

Tools required: Screwdriver

1. From bottom of gear case, turn adjustment screw (A) clockwise to

A

decrease oil volume - counter clockwise to increase oil volume.

 

NOTE

Very little visible oil on the saw chain will provide sufficient lubri- cation.