ASSEMBLY

Debris Shield

WARNING

Plastic Debris Shields are equipped with a sharp cut-off knife for cutting nylon trimmer line to length during op- eration. Use extreme care when assembling nylon line head to gear case to avoid accidental contact with cutoff knife. Wear work gloves when assembling nylon line head to gear case, and avoid contact with sharp cut-off knife edges.

Unit Configuration

GT Models: If your Model GT curved shaft trimmer is not fully assembled, you must assemble the unit as instructed in the Operator’s Manual provided with the unit. Before using the unit, make sure the plastic debris shield, trimmer head, and handle are properly attached, and are securely fastened.

If your GT curved shaft trimmer has been pre-as- sembled, you must make sure the plastic debris shield, handle, and trimmer head are properly installed and securely attached, as shown in the Operator’s Manual provided with the unit.

DANGER

NEVER install a metal blade on a model GT curved shaft trimmer. Use of any metal blade on a GT curved shaft trimmer can result in serious injury to operator and bystanders. Use only nylon line heads or GT series Maxi-Cut plastic weed trimmers approved for use on GT models by Echo. (See Set-up Guide page 15)

SRM Debris Shield

Cut-Off Knife

GT Debris Shield

Cut-Off

Knife

GT MODEL

Front Handle

GT Debris

Shield

Trimmer Head

NO Metal

Blades

14