STORAGE AFTER USE
•Drain remaining liquid out of the chemical tank.
•Inspect and adjust every part of the sprayer.
-Completely clean every part, and repair, if necessary.
-Apply thin coating of oil on metal parts to prevent rust.
-Remove spraying hose and pipe.
•Drain fuel tank, pull starter slowly a few times to drain fuel from carburetor.
•Pour a small amount of clean motor oil into spark plug hole, pull starter and crank the engine until the TOP DEAD CENTER.
•Store in a dry area, free from dust.
TECHNICAL DATA
Dimension | L × W × H | mm (in.) | 330 × 405 × 590 (13.0 × 15.9 × 23.2) |
Mass | w/o Spraying hose | kg (lb) | 7.4 (16.3) |
| and nozzle |
|
|
Capacity | Chemical liquid tank | L (gal.US) | 19.0 (5.0) |
Engine | Type |
| Air cooled, two stroke single cylinder |
| Displacement | mL (cu.in.) | 21.2 (1.3) |
| Rated speed | r/min | 7500 |
| Carburetor |
| ZAMA diaphragm type |
| Ignition |
| Flywheel magneto : CDI (Capacitor discharge |
|
|
| ignition) system |
| Spark plug |
| NGK BPM8Y |
| Starter |
| Recoil starter |
Fuel | Mixing ratio |
| Mixture of gasoline (unleaded, 89 octane |
|
|
| minimum) and specially blended 50 : 1 ECHO two |
|
|
| cycle engine oil. |
| Tank capacity | L (fl.oz.US) | 0.5 (16.9) |
Pump | Type |
| Regenerative pump |
| Discharge volume | L/min | 0.8 - 7.0 (27 - 236.7) |
| (Nozzle) | (fl.oz.US/min) |
|
| Pressure | MPa | 0.6 - 1.0 |
|
| kgf/cm2 (psi.) | 6 - 10 (85.3 - 142.2) |
Nozzle |
|
| |
Spraying hose |
|
| 7.5 mm φ (Inner diameter) |
|
|
|
|
* Technical data may be changed without advance notice.
* Other nozzles are available as optional supply.
- 13 -