DANGER

Fuel is VERY flammable. Use extreme care when mixing, storing or handling or serious personal injury may result.

Use an approved fuel container.

DO NOT smoke near fuel.

DO NOT allow flames or sparks near fuel.

Fuel tanks/cans may be under pressure. Always loosen fuel caps slowly allowing pressure to equalize.

NEVER refuel a unit when the engine is HOT!

NEVER refuel a unit with the engine running.

DO NOT fill fuel tanks indoors.

ALWAYS fill fuel tanks outdoors over bare ground.

Securely tighten fuel cap after refueling.

Inspect for fuel leakage. If fuel leakage is found, do not start or operate until leakage is repaired.

Move at least 3 m (10 feet) from refueling location before starting the engine.

Strainer

Chemical liquid tank

HANDLING FUEL

MIXING INSTRUCTIONS -

1.Fill an approved fuel container with half of the required amount of gasoline.

2.Add the proper amount of two-stroke oil to gasoline.

3.Close container and shake to mix oil with gasoline.

4.Add remaining gasoline, close fuel container, and remix.

IMPORTANT

Spilled fuel is a leading cause of hydrocarbon emissions. Some states may require the use of automatic fuel shut-off containers to reduce fuel spillage.

Stored fuel ages. Do not mix more fuel than you expect to use in thirty (30) days, ninety (90) days when a fuel stabilizer is added.

Stored two-stroke fuel may separate. ALWAYS shake fuel container thoroughly before each use.

AFTER USE -

DO NOT store a unit with fuel in its tank. Leaks can occur. Return unused fuel to an approved fuel storage container.

STORAGE -

Fuel storage laws vary by locality. Contact your local government for the laws affecting your area. As a precaution, store fuel in an approved, unoccupied building, away from sparks and flames.

CHEMICAL (Liquid)TANK

Fill the tank with liquid chemical through the strainer. Do not fill without strainer.

(Dust in the tank may cause clogging of the liquid line or pump.)

The tank contains 19 L (5.0 gal. US) of liquid.

(NOTE)

Each mark on the side of the tank indicates the 5, 10, and 15 L levels.

Ensure that tank cap is on tightly to avoid chemical leak.

It is not necessary to apply grease / oil to pump.

- 5 -