SPRAYING

•Ensure that chemical liquid valve is closed before starting engine.

•After engine is warmed up, turn throttle lever to the high speed position (Upper position) and open liquid valve.

(NOTE)

Since this unit is equipped with a centrifugal clutch, sprinkling is not possible when the engine is running at low speeds (idling).

- FOR SAFE OPERATION -

1.Secure the chemical tank cap.

2.Check all connections to avoid chemical leak. (Nozzle, Nozzle pipe, hose etc.)

3.Avoid wearing loose clothing and always wear safety glasses and gloves.

4.Use a face filter mask to avoid breathing chemical.

5.Check wind direction before spraying.

6.Do not point nozzle in the direction of people.

7.Stop the engine when refueling and / or replacing parts.

8.Close fuel chemical liquid valve when not in use.

9.Avoid using at engine speeds where the clutch slips.

STOPPING ENGINE

• Turn throttle lever to the lowest position and the ignition switch to STOP position.

(CAUTION)

When misting liquid is over, stop the engine. Do not keep engine running, when chemical tank has been emptied.

Ignition switch

1

4

5

3

 

2

 

 

1.

Nozzle body

4.

Nozzle

2.

Guide

5.

Cap

3.

Strainer

 

 

NOZZLE

•2-head nozzle (Standard type) is provided with this power sprayer.

•Standard nozzle discharge volume and pressure are as follows.

Chemical liquid Discharge:

2.4 L /min

81.2 Fl.oz US/min

(1.0 MPa)

(142.2 psi)

(NOTE)

-You can use a nozzle other than standard nozzle discharges liquid under 7.0 L at nozzle pressure:

1.0MPa (10 kgf/cm2) as required.

-Long hose (approx. 100 m) is available as required.

-In this case, use standard nozzle indicated above or less discharge volume nozzle.

•As for variety of optional nozzles, please refer to Page 1.

-7 -