GRASS TRIMMER/BRUSH CUTTER

OPERATOR'S MANUAL 13

ASSEMBLY

POWER HEAD SHAFT/LOWER SHAFT ASSEMBLY

Tools Required: None

Parts Required: Split Boom Attachment Assembly

1.Set Power Head/Shaft Assembly on a level surface.

2.Pull locator pin (A) out, and turn counter-clockwise 1/4 turn to lock- out position.

3.Remove cardboard spacer, if necessary.

3.Carefully fit attachment drive shaft assembly into coupler (B) to decal assembly line (C), making sure that the inner lower drive shaft engages the square upper drive shaft socket.

NOTE

Earlier model Power Heads may have shorter couplings. Short couplings fit flush to decal point (E). New couplings are 4-3/4 in. long, and fit flush to line (C).

NOTE

Lower bearing housing and head assembly must be in line with the engine.

4.Rotate locator pin (A) 1/4 turn clockwise to engage lower shaft hole. Insure locator pin is fully engaged by twisting lower drive shaft. Locator pin should snap flush in coupler. Full engagement will prevent further shaft rotation.

5.Secure lower shaft assembly to coupler by tightening clamping knob (D).

B

D

A

B

D

A

C

E