26 
NYLON LINE REPLACEMENT
Level 1.
Parts Required: ECHO 0.095 in. Nylon Trimmer Line 6 m (20 ft.) long.
1.Shut engine off. Lay unit on the ground with head assembly up.
2.Hold drum (A) and turn spool (B) CW (clockwise) until it stops. Pull spool from drum. DO NOT push in on spool when turning.
3.Use one piece of new nylon line (C) 6 m (20 ft.) long and thread through the molded loop (D) on the spool. Pull line tight and adjust so one end is 15 cm (6 in.) longer than the other.
4.Hold the spool, opening toward you. Place index finger between the two strands and wind line, tightly and evenly, in direction of arrow (E) marked "CC".
B
A
A
B
C |
| D |
|
|
|
|
|
|
| E |
|
C C |
|
|
|
|
|
5. Stop when approximately | B |
place ends of line in notches (F) in spool (B). |
F
F