Grass Trimmer/Brush Cutter 19
Operator's Manual
starting cold engine
WARNING
The attachment will operate immediately when the engine starts, and could result in possible serious injury. Keep movable parts of the attachment away from objects that could become entangled or thrown, and surfaces that could cause loss of control.
1.Stop Switch
Move stop switch button (A) forward away from the STOP posi- tion.
2.Choke
Move choke lever (B) to Cold Start Position (
).
3.Purge Bulb
Pump purge bulb (C) until fuel is visible and flows freely in the clear fuel tank return line. Pump bulb an additional 4 or 5 times.
NOTE
Lightly place knee on drive shaft to stabilize unit during starting. Do not apply excessive downward force or damage to unit can oc- cur.
4.Recoil Starter
Lay the unit on a flat area and keep movable attachment parts clear of all obstacles. Firmly grasp right hand grip and throttle trigger lockout with left hand and fully depress throttle trigger to wide open position. Rapidly pull recoil starter handle/rope (D) until engine fires (or maximum five [5] pulls).
5.Choke
After engine fires (or 5 pulls), move choke lever back to Run
(
) position. Hold throttle trigger and throttle trigger lockout fully depressed, and pull recoil starter starter handle/rope until engine starts and runs. Release throttle trigger, and allow unit to warm up at idle for several minutes.
NOTE
If engine does not start with choke in “Run” position after 5 pulls, repeat instructions 2 - 5.
6.Throttle Trigger
After engine
A
B 
C
D
