Locking tool

Upper fixing plate

 

 

Cutting

 

head

TIGHTEN

CUTTING PROCEDURES

PULL

Quick release latch

INSTALLATION OF NYLON LINE HEAD (OPTION)

Set the nylon line head to the drive shaft and tighten by turning as shown.

OPERATING INSTRUCTIONS nylon line

1.Always use the end of the line for cutting. Forcing the cutter head too close to the work will result in reduced efficiency and broken line.

2.Maintain the line at the recommended length of 12.5 to 15 cm ( 5 to 6 inch ). A longer line will reduce engine speed, a shorter line may result in engine damage.

3.The trimmer head rotates counterclockwise. Always cut with the head tilted to the right to deflect debris away from the operator.

4.Always observe the SAFETY RULES on Page 2 when using the unit.

SHOULDER HARNESS

∙Install the harness over the both shoulders and adjust shoulder straps so that the quick release latch rests low on the right hand side.

∙Attach the trimmer/brushcutter to the harness by means of the quick release latch.

∙Make some practice sweeps as with a trimmer and readjust the harness as necessary for comfort and to maintain the cutter parallel to the ground.

WARNING DANGER

IN CASE OF EMERGENCY, PULL THE QUICK RELEASE LATCH TO DISCONNECTTHE TRIMMER FROM THE HARNESS.

- 10 -