Echo TC-210 specifications Gear Housing, Tine Removal/Cleaning - Installation, Maintenance

TC-210 MAINTENANCE

Gear Housing

D

1.Remove tines (See Tine Removal/Cleaning - Installation below).

2.Remove gear case cover (A). Be careful not to tear sealing gasket (C).

3.Support tiller with exposed gear case (D) upward. Add grease until nearly level with top of gear case (D).

A C

B

Do not over fill. Too much grease will cause pressure and possible seal failure.

Tine Removal/Cleaning - Installation

Note: Always wear gloves to protect hands from sharp blades.

Stop engine and disconnect spark plug wire before removing or installing tines. Contact with revolving tines will cause severe injury.

1.Remove retaining pin (E) and slide tine from shaft.

2.Remove weeds, etc. from tines and wash dirt from unit.

3.Clean accumulated dirt and debris form gear housing and tine shaft.

4.Select "Tilling" or "Cultivating" position, and install tines facing forward (tilling) or rearward (cultivating).

5.Slide tine on shaft, long hub first. D-hole (hole with flat side) goes to the outside. (D-hole in outer hub aligns with flat on shaft.).

6.Install retaining pin (E).

E

E

X7504083607 27

© 9/2014 ECHO Inc.