Chain brake
Ignition switch
Start / Run
Choke control knob 
Choke | Purge pump |
Starter handle
Chain brake
Ignition switch
Start / Run
Choke control knob 
Choke | Purge pump |
Starter handle
WARNING
•After choke control knob is pulled and then knob is returned to original position, throttle remains slightly open (latch condition).
•The chain will attempt to rotate when engine is started with throttle latch engaged. •Do not start engine before chain brake is activated.
CAUTION
•After starting the engine, squeeze throttle trigger slightly to release throttle latch, otherwise brake damage may occur.
•Never use throttle latch for cutting.
•Use the throttle latch only in starting.
WHEN THE ENGINE IS COLD
CAUTION
Make sure the bar and chain are free from any obstruction when starting the chain saw.
•Move chain brake lever fully forward to lock chain brake before starting.
•Fill the fuel tank with fuel mixture.
It is not permitted to fill fuel above the shoulder level of fuel tank.
•Fill the chain oil tank with lubricant. Do not over fill.
•Move ignition switch to “RUN” position.
•Push purge pump 3 to 4 times or until fuel is visible in purge pump.
•Pull choke control knob all the way out. (Choke posi- tion)
NOTE
Do not pull starter rope out to the maximum possible position.
Do not allow recoil handle to snap back against the
casing.
•Securely hold the chain saw as shown and pull starter handle several times until first firing sound.
•Push choke control knob all the way in.
•Pull starter handle to start the engine.
•When engine starts, immediately squeeze throttle trig- ger, to release throttle latch.
CAUTION
Do not increase engine speed while chain brake is locked.
| NOTE |
| If engine does not start after 5 pulls, repeat instruc- |
| tions. |
17 |
