Kickback motion
Improper thrust cutting
Kickback motion
When the bar nose hits another tree, etc.
Chain brake function
When the lever is pushed forward, chain brake instantly stops the chain.
Chain brake unlock
When the lever is fully pulled toward the operator, brake is unlocked.
CHAIN BRAKE OPERATION
•Set the lever in the unlocked position before starting to cut.
•If the brake is tripped by kickback reaction, the chain will stop immediately. Release the throttle to avoid possible damage to the engine or clutch.
•Do not attempt to operate the engine with the brake locked.
TESTING THE BRAKE
•Start the engine on a solid level surface and run at a fast idle until warm.
•Hold the saw firmly by the handles and accelerate the engine to a fast idle.
•Slowly operate the chain brake lever while holding the saw firmly on the ground.
When the brake lever trips, the chain should stop. Immediately release the throttle trigger.
WARNING
If the chain does not stop immediately, return the saw to your authorized ECHO dealer for repair.
NOTICE
•For practice, while cutting a small tree, push the lever forward to lock the brake.
•Confirm that the brake works properly before each use.
•If the chain brake is clogged with wood chips, func- tion of the brake may deteriorate. Always keep the device clean.
•Do not increase engine revolution while the chain brake is locked.
•When using throttle latch at starting, keep the chain brake locked.
IMPORTANT
Do not allow the saw to tip forward in order to avoid damage to the chain.
22 |
