Eclipse - Fujitsu Ten CD1000 manual Manually setting stations into memory

Operation

ATTENTION

•Pressing the preset buttons ([1] to [6]) allows you to make one-touch station selections. The frequency of the selected station is indicated on the display.

•When a new station is set in memory, the station previously set in memory will be deleted.

•If there are fewer than six receivable stations, the stations set in the remaining buttons will be retained.

Manually setting stations into memory

This section covers the setting of stations in memory under the numbered buttons.

1 Press the [BAND] button.

You can switch the mode to desired one.

Select a station (see page 17).

Press a button from [1] to [6] for

2 several seconds.

Select any button, from [1] to [6],

3 and press it for more than two seconds.

The tuned station is now memorized and set in the selected button. Repeat the procedure to set additional manually tuned stations in memory, in turn, for the buttons [1] to

[6].These buttons are called the preset buttons.

Changing the radio band location

The location for the radio bands used between the North American region and the Asia/ Australia/Latin region can be switched. The default setting is USA (North America).

1	Press the [MODE] button for
	several seconds.
	The mode will be switched to the
	function mode.
	Press the [ ] or [ ] button to
2
	switch the mode selection.
	[AREA] will be displayed.
	Turn the control dial to select the
3
	region.

USA ➔➔ ASIA ➔➔ AUS ➔➔ LATIN

Switching to the monaural mode

If FM stereo is difficult to receive,switch to the monaural mode to receive it.

You cannot listen to FM broadcasts in stereo when the monaural mode is activated.

Press the [BAND] button to switch

1 to the desired FM bands.

2 Press the [FUNC] button.

Press the [2] button while [FUNC]

3 is blinking.

[MONO] appears on the display.

● MEMO ●

• The monaural mode can be canceled in the same procedure.

• [MONO OFF] appears on the display

18