4 LED Indicators

4 LED Indicators

Before connecting any network device to ECOM-ES24F2GFast Ethernet Switch, you should take a few minutes to look over this chapter and get familiar with the front panel LED indicators of your Switch.

System LEDs

10/100Mbps Port LED Gigabit LED

System LEDs

-Power (green) to indicate power on/off status

-LoopDet (yellow) to indicate network loop has formed inside the network. You can use the management program’s diagnostic function to find out which port the loop occurs.

-DIAG (yellow) to indicate the power on self test (POST) fails status, which indicate a fault chip.

10/100Mbps Port LEDs

For port 1 ~ port 24

-Link/Act (green) to indicate linking status and activity

-FDX/Col (yellow) to indicate Full Duplex transmission mode and collision status

-100 M LED (red) to indicate 100 Mbps speed

Gigabit Port LED

For port G1 and G2

-Link/Act (green) to indicate linking status and activity

-FDX/Col (yellow) to indicate Full Duplex transmission mode and collision status

-100/1000M LED: (Green) to indicate 1000 Mbps speed

(Orange) to indicate 100 Mbps speed

14

Ecom ES24F2G Gigabit Ethernet Switch User’s Manual V1.0

Page 22
Image 22
Ecom Instruments ECOM-EF24F2G user manual LED Indicators, System LEDs, 10/100Mbps Port LEDs, Gigabit Port LED