zTo remove any remaining tape or glue, rub the area briskly with your thumb. Tape or glue residue can also be easily removed by rubbing a small amount of liquid dish soap over the adhesive with your fingers. Wipe with warm water and dry.
zDo not use sharp instruments, rubbing alcohol, flammable fluids, or abrasive cleaners to remove tape or glue. These products can damage the surface of your icemaker.
Cleaning before use
After you remove all of the packaging materials, clean the inside of your icemaker before using it. See the "Interior cleaning" in the Cleaning and Maintenance section.
Location Requirements
zThis icemaker should be installed by a licensed plumber only.
zTo ensure proper service access and ventilation, allow more 2/5” clearance at rear, and 1” at top and 1/5” at sides. The installation should allow the icemaker to be pulled forward for servicing if necessary.
zWhen installing the ice maker under a counter, follow the recommended spacing dimensions shown. Place electrical and water supplies and drain fixtures in the recommended locations as shown.
zChoose a well ventilated area with temperatures above 50°F and below 100°F.This unit MUST be installed in an area protected from the elements, e.g., wind, rain, water spray or drips.
zThe icemaker should not be located next to ovens, grills or other high heat resources.
zThe ice maker requires a continuous water supply with a minimum pressure of 0.05Mpa and a static pressure not to exceed 0.8Mpa. The temperature of the water feeding into the ice maker should be between 41°F and 90°F for proper operation.
10
