Problem, Possible Cause | EdgeStar IB450SS guide

Problem	Possible Cause
	The icemaker is unplugged.
The machine won't	The fuse is blown.
The machine won't	The icemaker power switch is
operate.	OFF.
	The ice storage bin is full of
	ice.
The water doesn't	The water supply tap is turn
feed in after the ice	off.
maker starts.	The water supply pipe is not
	proper connected.
	The condenser may be dirty.
Machine makes ice,	The air flow to the ice maker
Machine makes ice,	may be obstructed.
but bin does not fill	The ambient temperature and
up with ice	water temperature are high, or
	it is near with some heat
	source.
	A few water droplets are on the
	door.
Water is leaking out
the unit.
	The water supply connection is
	leaking.
Cubes are partially	Not enough water in the water
formed--are white	bin.
at the bottom.

Noise during	The feet are not leveled and
operation	locked
	Certain sounds are normal.
	The electricity is off.
The icemaker stops	The room temperature is out of
suddenly while	the stated range.
making ice.
The body of the ice	The ground line isn't in the
maker is electrified	socket.

Scale builds up	The calcium level in the water
quickly inside the	is too high.
machine.

Probable Correction Plug the ice maker in. Replace fuse.

Turn the ice maker power switch to ICE (ON)

Take away some ice cubes; make the ice-full probe is free of ice.

Turn on the water supply tap.

Reconnect the water supply pipe.

Clean the condenser.

Check the installation.

Under some conditions, humidity may condense on the door. Consider moving the unit or just be more careful when you open the door.

Tighten fitting. See “Connecting the water line”.

Check if the water supply pressure is below 0.05Mpa.

Check water supply--filter may be restricted.

Check for a water leak at the water trough. Level and lock the feet. See Leveling the Ice Maker.

See “Normal Sounds.” Reconnect the power supply line.

Cut off the electricity and let the ice maker stop working until the temperature returns within the stated range.

Use the correct plug and outlet.

Use a water-softening apparatus installed in front of the water inlet valve.