![](/images/new-backgrounds/1113862/11386229x1.webp)
9.Press the Select Button
10.Select the Upload New Configuration to Control Button
Or
11.The software will prompt you to press the reset button. (reset button is located on the back of the EZ 250)
Reset Button
12.After the programming status disappears disconnect the cables from the computer and press the reset button on the back of the EZ 250 and you are ready for the installation of the EZ 250
Reset Button
Standard Programming for a LSE device and a another Device
1.Same as steps 1 thru 7 in Standard Programming
2.Select Control Ports
3.Select Enable LSE Device (this will be on RS232- 2 so you must connect your other device on
4.Select Upload New Configuration to Control
Or
- 11 -