![](/images/new-backgrounds/1112452/112452101x1.webp)
REMOTE CONTROL CODE CHANGE (Mode 1 or Mode 2)
This projector can be operated with two different code, one is
This is used to prevent the remote control operation mixture (jam) when two projector and several remote control video equipments are
When you change the code MODE 2, you must change both projector and Remote Control Unit.
To change Projector code
Set REMOTE CONTROL in SETTING menu (below figure) to “MODE 2”.
To change Remote Control Unit code
Press both “MENU” and “NORMAL” button on the Remote Control Unit for over 10 seconds.
After code changed, make sure the Remote Control operation is functioning properly. To go back to normal code (MODE 1), take same operation above.
Setting the Blue back, Display, Reverse T/B, Reverse
R/L, Split wipe, Power management, USB and Remote control
1.Press the MENU BUTTON and the MAIN MENU DISPLAY dialog box will appear.
2.Press the POINT LEFT/RIGHT BUTTON(s) to select SETTING and press the SELECT (REAR CLICK) BUTTON. Another dialog box SETTING DISPLAY will appear.
3.Press the POINT DOWN BUTTON and a red arrow will appear.
4.Move the arrow to an item you want to set by pressing the POINT UP/DOWN BUTTON(s).
5.If you want to change the setting, press the SELECT (REAR CLICK) BUTTON.
6.To quit the MENU, point to Quit and then press the SELECT (REAR CLICK) BUTTON.
7.The settings are memorized even if the MAIN ON/OFF is switched off.