Eiki LC-X71L owner manual Troubleshooting, Problem, Try these Solutions

APPENDIX

TROUBLESHOOTING

Before calling your dealer or service center for assistance, check the items below once again.

1.Make sure you have connected the projector to your computer or video equipment as described in “CONNECTING PROJECTOR” on pages 12-14.

2.Check the cable connection. Make sure that all computers, video equipment, and power cords are properly connected.

3.Make sure that all power is switched on.

4.If the projector still does not produce an image, restart your computer.

5.If an image still does not appear, disconnect the projector from your computer and check your computer monitor’s display. A problem may be noticed with your graphics controller rather than with the projector. (When you reconnect the projector, be sure to turn the computer and monitor off before you turn on the projector. Turn on equipment in the order of the projector and computer.)

6.If a problem still persists, check the following solutions.

Problem:	Try these Solutions
No power.	● Plug the power cord of the projector into an AC outlet.
	● Make sure the READY indicator lights.
	● Wait 90 seconds after the projector is turned off to restart the projector.
	NOTE: After pressing the POWER ON-OFF button to “OFF”, make sure the projector works
	as follows:
	1. LAMP indicator lights bright and the READY indicator turns off.
	2. After 90 seconds, the READY indicator lights green again and the projector may
	be turned on by pressing the POWER ON-OFF button.
	● Check the WARNING TEMP. and READY indicators. If both indicators blink, the projector
	cannot be turned on.
	(See “TURNING ON/OFF PROJECTOR” on pages 20-21.)
	● Check the projection lamp. (See page 48.)
Image is out of	● Adjust the focus of the projector.
focus.	● Make sure the projection screen is at least 4.6’ (1.4 m) away from the projector.
	● Check the projection lens to see if it needs cleaning.
	NOTE: Moving the projector from a cool to a warm place may result in moisture
	condensation on the projection lens. If this happens, leave the projector off and wait
	until condensation evaporates.
Picture is left/right	● Check the Ceiling/Rear function. (See “SETTING” on page 40.)
reversed.
Picture is top/bottom	● Check the Ceiling function. (See “SETTING” on page 40.)
reversed.
Some displays are	● Check the Display function.(See “SETTING” section on page 38.)
not seen during
operations.
No image.	● Check the connection between your computer or video equipment and the projector.
	● When turning the projector on, it takes about 30 seconds to display the image.
	● Check the system you selected is corresponding to your computer or video equipment.
	● Make sure the temperature is not out of specified operating temperature (41 ˚F ~ 95 ˚F
	(5 ˚C ~ 35 ˚C)).
No sound.	● Check the audio cable connection from an audio input source.
	● Adjust the audio source.
	● Press the VOLUME (+) button.
	● Press the MUTE button.

50