Eiki LC-XB23 Lamp Replacement, Order Replacement Lamp, Model No. of your projector, POA-LMP90

Maintenance and Cleaning

Lamp Replacement

When the life of the projection lamp of this projector draws to an end, the LAMP REPLACE indicator emits a yellow light. If this indicator lights yellow, replace the lamp with a new one promptly.

	This indicator is yellow when
	the life of the projection lamp
WARNING:
	draws to an end.

TURN OFF THE UV LAMP BEFORE

OPENING THE LAMP COVER

Top Control

POWER WLAMP REPLACE

ON	INPUT	KEYSTONE
SELECT
VOLUM		+
		VOLUME
-
E

CAUTION

Allow a projector to cool, for at least 45 minutes before you open the Lamp cover. The inside of the projector can become very hot.

CAUTION

For continued safety, replace with a lamp of the same type. Do not drop a lamp or touch a glass bulb! The glass can shatter and may cause injury.

Follow these steps to replace the lamp.

1	Turn off the projector and disconnect the AC power
	cord. Allow the projector to cool for at least 45
	minutes.
2	Remove the screw with a screwdriver, and remove
	the lamp cover.
3	Remove 2 screws of the lamp with a screwdriver and
	pull out the lamp by grasping the handle.
4	Replace the lamp with a new one and tighten the 2
	screws back into position. Make sure that the lamp is
	set properly. Replace the lamp cover and tighten the
	screw.
5	Connect the AC power cord to the projector and turn
	on the projector.
6	Reset the lamp replacement counter.
	See “Lamp Replacement Counter” on the next page .

Lamp Cover Screw

Screw

Lamp

Screw Handle

ORDER REPLACEMENT LAMP

Replacement lamp can be ordered through your dealer. When ordering a projection lamp, give the following information to the dealer.

●	Model No. of your projector	: LC-XB23
●	Replacement Lamp Type No.	: POA-LMP90
		(Service Parts No. 610 323 0726)

52