Maintenance and Filter Cleaning
Resetting the Lamp Counter
Be sure to reset the Lamp counter after the lamp is replaced. When the Lamp counter is reset, the LAMP REPLACE indicator stops lighting and the Lamp replacement icon disappears.
1 | Press the MENU button to display the | Lamp counter |
| Menu. Use the Point 7 8 buttons to move the red |
|
| frame pointer to the Setting Menu icon. |
|
2 | Use the Point ed buttons to move the red frame |
|
| pointer to Lamp counter and then press the SELECT |
|
| button. A dialog box appears showing the total |
|
| accumulated time of the lamp usage and the reset |
|
| option. Select Reset and the “Lamp replacement |
|
| counter Reset?” appears. Select [Yes] to continue. |
|
3 | Another confirmation dialog box appears, select [Yes] |
|
| to reset the Lamp counter. |
|
✔Note:
•Do not reset the Lamp counter without implementing lamp replacement. Be sure to reset the Lamp counter only after replacing the lamp.
Select Reset and the “Lamp replacement counter Reset?” appears.
Select [Yes], then another confirmation box appears.
Select [Yes] again to reset the Lamp counter.
LAMP HANDLING PRECAUTIONS
This projector uses a
●Lamp life may differ from lamp to lamp and according to the environment of use. There is no guarantee of the same life for each lamp. Some lamps may fail or terminate their life in a shorter period of time than other similar lamps.
●If the projector indicates that the lamp should be replaced, i.e., if the LAMP REPLACE indicator lights up, replace the lamp with a new one IMMEDIATELY after the projector has cooled down.
(Follow carefully the instructions in the Lamp Replacement section of this manual.) Continuous use of the lamp with the LAMP REPLACE indicator lighted may increase the risk of lamp explosion.
●A Lamp may explode as a result of vibration, shock or degradation as a result of hours of use as its lifetime draws to an end. Risk of explosion may differ according to the environment or conditions in which the projector and lamp are being used.
IF A LAMP EXPLODES,THE FOLLOWING SAFETY PRECAUTIONS SHOULD BE TAKEN..
If a lamp explodes, disconnect the projector’s AC plug from the AC outlet immediately. Contact an authorized service station for a checkup of the unit and replacement of the lamp. Additionally, check carefully to ensure that there are no broken shards or pieces of glass around the projector or coming out from the cooling air circulation holes. Any broken shards found should be cleaned up carefully. No one should check the inside of the projector except those who are authorized trained technicians and who are familiar with projector service. Inappropriate attempts to service the unit by anyone, especially those who are not appropriately trained to do so, may result in an accident or injury caused by pieces of broken glass.
60
