PC ADJUSTMENT

This Projector can automatically tune to the display signals from most personal computers currently distributed. However, some computers employ the special signal formats which are different from the standard ones and may not be tuned by Multiscanning of this projector. If this happens, the projector cannot reproduce a proper image and the image is recognized as a flickering picture, a non-synchronized picture, a non-centered picture or a skewed picture.

This projector has PC ADJUSTMENT function, to enable you to precisely adjust several parameters to match with those exceptional signal formats and the projector has five independent memory areas to memorize those parameters manually adjusted. This enables you to recall the setting for a specific computer whenever you use it.

1

Press the MENU button and the ON-SCREEN MENU will

 

appear. Press the POINT RIGHT/LEFT buttons to select PC

 

ADJUST

and press the SELECT button. Another dialog

 

box “Where to reserve” Menu will appear.

2

In this dialog box, you can store the parameter into the area

from “Mode 1” to “Mode 5.” When memorizing the new

 

computer parameter, select the Mode with the message of

 

“Free” by pressing the POINT UP/DOWN buttons and the

 

SELECT button. To change the parameters of the Mode

 

previously set, select the Mode with “Stored.”

3

When the Mode is selected, Parameter adjustment dialog box

appears. Move the arrow to the item that you want to change

 

by pressing the POINT UP/DOWN buttons, and adjust the each

 

item to match with your computer. To change the value, press

 

either the POINT RIGHT button or the POINT LEFT button.

 

Refer to the next page for adjusting each item.

4

Move the arrow to “Stored” and press the SELECT button. The

parameter is memorized in the selected Mode.

5

To activate the Mode manually adjusted in this PC

ADJUSTMENT Menu, select the Mode at the SYSTEM

SELECT Menu. (Refer to page 22.)

GB

This Mode has parameters being stored.

The Vacant Mode.

Manual set Computer

Mode (1 to 5).

It closes the PC

ADJUSTMENT Menu.

Press the POINT RIGHT/LEFT button(s) to adjust the value.

Press the SELECT button to set Full screen function on/off.

24