Eiki PJNET-30 Installation and network configuration, Mounting, Connection of LAN cable

Setting up

Installation and network configuration

Mounting

1 Disconnect the AC plug from the projector.

2 Remove the connector cover and screw covers (2 pieces) from the projector and insert plug on this product to the option connector.

3 Tighten two screws by using a coin etc.

Screw Cover

Connection of LAN cable

Connector Cover

Screw Cover

To connect to the network, it is required to use the UTP (Unshielded Twisted Pair) straight cable with RJ-45 plug. There are two different types of cables depending on whether the network is constructed with 10Base-T or 100Base-TX. Prepare the Hub (10Base-T or 100Base-TX) to distrib- ute the network cable if required.

1 Disconnect the AC plug from the projector.

2 Connect the UTP straight cable to the LAN port on the network unit. 3 Connect the UTP straight cable to the hub.

Hub

(10Base-T, 100Base-TX)

Projector

UTP straight cable

✐AC cord must be disconnected when mounting or removing this product otherwise it may dam- age the product.

✐Use the UTP cross cable when you connect the computer and projector directly not using the hub.

✐When you connect the projector into the 10Base-T network, use cable with category 3 or 5. When you connect the projector into the 100Base-TX network, use cable with category 5.

✐The length of cable between hub and projector should be less than 100m.

Pj-to NetDIrector

QUICK SETUP GUIDE

ENGLISH