Eiki PJNET-30 Network configuration, Confirmation of the network menu, Configure the network

Setting up

Network configuration

Confirmation of the network menu

When installing this product to the projector, the network on-screen menu items for this product are activated automatically. If not activated, the product may not have been installed correctly. Please check item "Mounting" (☞ p.7).

Configure the network

Before performing the network configuration, prepare network address numbers (IP Address, Subnet Mask, Default Gateway, DNS) assigned to the projector. Ask your network administrator for the network address.

For example, the case where the following network address is set up is explained.

IP Address	: 192.168.1.201
Subnet Mask	: 255.255.255.0
Default Gateway	: 192.168.1.1
DNS	: 0.0.0.0

The default network configuration is set as follows.

IP Address	: 192.168.0.2
Subnet Mask	: 255.255.255.0
Default Gateway	: 0.0.0.0
DNS	: 0.0.0.0

LINK ACT

1 Selection of network menu

Turn on the projector and display the menu on the screen. Select "Network setting" icon from the main menu and then press SELECT button once. Check that the mode is "On". If not, change mode to "On" using the point buttons (7,8).

Network icon

Select "On" or "Off" with 7,8 button

(Example of the screen display)

✐ The network unit begins restarting each time the mode is set "On".