Eiki PJNET-30 Configuration for IP Address/ Sub net/ Gateway*1/DNS*2, Completing of installation

Setting up

2Configuration for IP Address/ Sub net/ Gateway*1/DNS*2

Press SELECT button again. The following network setting pallet appears on the screen. Enter the specified network addresses.

The red frame moves sequentially left or right with 7 8 button. The number up or down with d e button.

(Example of the screen display)

*Without the above method of using point buttons, there are some methods to set the network address, using the screen 10-key pallet or using the direct 10-key entering with the remote control. But these methods differ depending on each model of the projec- tor. See PJ-Net Organizer Owner's manual on the CD-ROM for further instructions

3 Fixing the network configuration

After completing the entering of address, select "Set" and
press SELECT button. The network unit starts re-booting
and displays message "Please wait..." on the screen until
the re-booting is complete. Do not disconnect the AC
cord during this period. After that the network setting pallet	(Example of the screen display)
will disappear on the screen.

Completing of installation

Now the installation is complete. The IP address of this projector is set to "192.168.1.201".

Item	Description
IP address	Sets IP address of the projector
Sub net	Sets Subnet mask. Normally sets 255.255.255.0
Gateway*1	Sets IP address of the default gateway (Router)
DNS*2	Sets IP address of the DNS server. Must be set when using the e-mail function

✐Refer to the projector's owner's manual for operation of the projector.

ENGLISH

*1 In the network environments not using a Gateway or Router, the Gateway address should be set to [0.0.0.0]. *2 If you do not use the functions E-mail or DNS server, it is also set [0.0.0.0] for the DNS address.

Pj-to NetDIrector

QUICK SETUP GUIDE