
English
5. CALIBRATION
The calibration is available when using the specified optional calibration kit (p.38).
Accessories for Calibration Kit
•Photo Sensor x 1
•Maintenance cable x 4
•Calibration Software
Mini DIN 6 pin
Mini DIN 8 pin
Photo Sensor
Maintenance cable
PC
1. Confirm the graphics board settings (If the graphics board has the settings below). Please read the User’s manual of the graphics board in details.
•Set the output signal level to “Linear” or "Static Gray".
•Release the “Setup (i.e. the function to up to the black level)” when using the analog graphics board.
2.Plug the maintenance cable into the REMOTE IN (Mini DIN 6 pin) connector of the monitor and the other end of the cable into the serial port
3.Plug the photo sensor to the photo sensor connector (Mini DIN 8 pin) of the monitor.
4.Install the calibration software and calibrate the monitor.
About the directions (for use), please read the user’s manual of the software.
26 5. CALIBRATION