
English
6. TROUBLESHOOTING
If a problem persists even after applying the suggested remedies, contact an EIZO dealer.
•No picture problems : See No.1 ~ No.2
•Imaging problems : See No.3 ~ No.8
•Other problems : See No.9
| Problems | Points to check with possible solutions |
1. | No picture | Check that the power cord is correctly |
| • Indicator status: Off | connected. If the problem persists, turn off the |
| monitor power for a few minutes, then turn it | |
|
| |
|
| back on and try again. |
| • Indicator status: Blue | Check the Brightness setting. (p. 19) |
|
| Switch the signal input. Pressing the left control |
|
| button without displaying the ScreenManager |
| • Indicator status: Yellow | changes input signal. (p. 14) |
| Try pressing a key on the keyboard, or clicking | |
|
| |
|
| the mouse. (p. 21) |
|
|
|
2. | Following messages appear. (Error | These messages appear when the signal is not |
| messages shown below will remain | inputted correctly, even if the monitor functions |
| on the screen for 40 seconds.) | properly. |
|
| When the image is displayed correctly after a |
|
| short time, there is no problem with the |
|
| monitor. (Some PCs do not output the signal |
|
| soon after powering on.) |
|
| Check that the PC is turned ON. |
|
| Check that the signal cable is properly |
|
| connected to the PC or graphics board. |
|
| Switch the signal input. Pressing the left control |
|
| button without displaying the ScreenManager |
|
| changes input signal. (p. 14) |
| • Whenever an error signal message | Use the graphics board’s utility software to |
| appears, the signal frequency will be | change the frequency setting. (Refer to the |
| displayed in red. (Example) | manual of the graphics board.) |
|
|
|
|
|
|
6. TROUBLESHOOTING 23