English

NOTE

ξ Whenever finished, turn off the PC and the monitor. Disconnecting the monitor from the power supply is recommended to save energy completely.

ξ Adjust brightness of the screen depending on the brightness of your environment. Too dark or too bright of a screen can cause eyestrain.

ξ Be sure to take adequate rests. A 10-minute rest period each hour is suggested.

2-3. Touch Operation

Point and touch with one finger only.

NOTE

ξ Do not touch the screen while the computer is starting. Touch the screen after disappearing TouchWare starting window.

ξ Do not touch the screen while turning on the monitor. Touch the screen one second later after appearing the image.

ξ For the users with gloves, we recommend to use touch panel pointer, “TP1” (optional). Regarding the installation, please refer to the User’s Manual of TP1.

2-4. Connecting two PCs to the monitor

Two PCs can be connected to the monitor through the DVI and the D-Sub mini 15 pin connector on the back of the monitor.

Selecting the active input

The Input Signal Selection Button on the control panel can be used to select either Signal 1 or Signal 2 as the active input at any time. Every time the button is pressed, the input changes. When switching the signal, the kind of the input signal (Signal1 or 2/Analog or Digital) is displayed for a few seconds on the right top corner of the screen.

Input Signal Selection Button

SIGNAL MODE AUTO ENTER 1 - 2

2. CABLE CONNECTION 15