Design Wash 1400E™
©Elation Professional® 11 Design Wash 1400E™
6. LAMP INSTALLATION INSTRUCTIONS
For a proper and safe lamp change, please read this chapter carefully and follow all
instructions.
Safety Regulations
• Disconnect the unit’s main power supply.
• Allow the unit to cool for at least 15 minutes before attempting any type of service.
• Before you put the Design Wash 1400E™ back into operation after a lamp change,
be sure all covers have been replaced and/or closed and secured. Operating the
fixture with the covers removed risk damage to the retina and exposure to harmful
UV radiation!
• Replace the lamp with an approved replacement type. Be sure to follow all the lamp
handling procedures included with your new lamp. Never handle the new lamp with
your bare hands as the oils from your skin may damage the lamp. Always replace
with a lamp that meets the original lamp specification, failure to do so may damage
the unit and will void your manufactures warranty.
Installation Procedure:
1. Set the fixture on a flat surface and remove the four screws labeled “A” “B,” “C,” and
“D” found on the back plate of the head assembly to access the lamp.
2. Gently remove the old lamp by grasping the ceramic base and turning it
counter-clockwise until it is loose.
3. Insert the new lamp securely, locking the lamp by turning it clockwise until it locks in
place. Before reassembling the unit, be sure the new lamp is securely seated in the
lamp socket. Always be sure to only use specified lamp types! (MSR Gold 1200