Elation Professional 700 II

Power Spot 700 II™

©Elation Professionals® Lo s Angeles, Ca. - wwww.ElationLig hting.com - Page 48

fasteners will remain connected to the lamp socket cover.

5. Gently remove the old lamp from it’s socket. If the old lamp has exploded be sure

to remove all of the old lamp fragments to prevent damage to the internal

components.

6. Insert the new lamp securely, locking the

lamp in place as illustrated in the diagram

to the left. Orientate the lamp filler tube

towards the backside of the reflector.

Before reassembling the unit, be sure the

new lamp is securely seated in the lamp

socket. Always be sure to only use

specified lamp types!

 

7. Gently replace the lamp socket assembly in to place and secure with the four

quick release fasteners.

8. Be sure to reset the lamp running time in the “TIME“ menu. The lamp run time is

designed to function as lamp replacement reminder (see page 23).

9. Final step would be to properly optimize the lamp. Follow the steps below to

properly align the lamp and inside the reflector.

Attention:

Be sure the lamp is securely seated in the lamp socket. Failure to comply

with this warning may cause excessive heat build-up that may cause the

internal lens to crack.

Lamp Optimization:

You should adjust the lamp position after each lamp replacement. This is necessary

due to the fact that every lamp has small manufacturing variations. The Power Spot

700 includes a lamp optimization system, consisting of two set screws on the back

lamp socket cover (set screw A and B). The lamp adjustment is a matter of the users

taste but will best be done as follows:

1. Using a flathead screwdriver move the lamp position with setscrew “B” forwards

and backwards until a very bright luminous spot (hotspot) can been seen clearly.