Fitting the hob to the worktop
Before fitting the hob into the cut out, a sealing gasket supplied with the hob must be fitted to the edge of the cut out. It is essential that no gaps are left in this seal in order to prevent spillage near the hob seeping into the cabinet below.
Φ |
|
|
1) Place the sealing gasket all around the edge | Seal | |
| of the cut out. | |
|
|
2)Place the hob into the cut out and secure it by means of the relevant fixing clamps and
screws, as shown in the diagram. | FO 0199 |
|
3) Remove the excess seal
The edge of the hob forms a double seal which prevents the ingress of liquids.
Electrical connections
Any electrical work required to install this hob should be carried out by a qualified electrician or competent person, in accordance with the current regulations.
THIS HOB MUST BE EARTHED.
The manufacturer declines any liability should these safety measures not be observed. This hob is designed to be connected to a
Before switching on, make sure the electricity supply voltage is the same as that indicated on the hob rating plate. The rating plate is located on the bottom of the hob. A copy is attached on the back cover of this book.
The hob is supplied without supply cord. A 3 core flexible supply cord must be fitted, in accordance with the specification given in the relevant tables.
1)Remove the mains terminal cover plate from the underside of the hob, to expose the mains terminal block.
2)Loosen the two cable clamp screws and lift the top section of the clamp enough to allow the cable to be passed through.
3)Connect the red (live) wire to the terminal which is marked with the number 1.
4)Connect the black (neutral) wire to the terminal which is marked with the number 4.
5)After fitting a green or yellow/green sleeve over the bare copper wire (earth wire), connect the exposed end to the terminal which is marked with the earth
symbol or with the number 5.
NOTE: The earth wire should be about 2 cm. longer than the live and neutral wires.
6)Secure the cable by means of the clamp screws and
refit the terminal block cover. | FO 0488 |
15