Electrolux 137356900 A manual Install Cycle, Reset

30Operating User Interface Features

Setting Preferences, continued

INSTALL CYCLE

Run the INSTALL CYCLE before operating the wash- er the first time. Remove all items from the washer drum and press start. For more information on performing the washer INSTALL CYCLE, refer to the Installation Instructions accompanying this washer.

If the washer has been installed according to Installation Instructions, INSTALL PASSED - DOOR CAN BE OPENED will be displayed and the washer

is ready to use.

If the washer was not installed properly, NO WATER -

OPEN WATER VALVES, WATER HOSES - CHECK WATER HOSES or CALL SERVICE 877 435 3287

will be displayed to indicate the installation error.

The errors may result from the following conditions:

•NO WATER —Water inlet hoses have not been at- tached to water supply or water supply valves have not been turned on. Install hoses correctly and turn on water supply valves.

•CHECK HOSES —The hot inlet hose may have been connected to the cold water supply and the cold inlet hose may have been connected to the hot water supply. Check hoses for correct sup- ply connection. If incorrect, disconnect hoses and connect to correct inlets according to Installation Instructions.

•CALL SERVICE 877 435 3287—Error can only be corrected by calling a qualified technician (1- 877-435-3287).

Repeat the INSTALL CYCLE when corrections are completed.

RESET

Press the buttons indicated to restore only cycle set- tings, reset only factory preferences (users, language, brightness, volume, etc.) or restore all factory defaults (both cycle settings and factory preferences). Press the button under EXIT to return to normal operation or press the cancel button to turn the washer off without making any changes. If you do not make a selection within 30 seconds the washer will return to normal operation without any changes. If you reset all settings, INSTALL CYCLE will be displayed as though the washer were just turned on for the first time. You may press the button under CANCEL if you do not wish to rerun the INSTALL CYCLE.

NOTE

The INSTALL CYCLE is prompted automatically only once when the washer is turned on the first time at the end of installation. After that,

if you wish to run a subsequent INSTALL CYCLE when moving the washer or modifying your installation, you may perform your own INSTALL CYCLE by selecting it in the set prefs feature and then following the screen prompts.