Instructions for use
34
Water runs out from
under the machine.
The water inlet hose coupling
is loose. Tighten the hose coupling.
The outlet hose is loose. Check the outlet hose and
replace if necessary.
The detergent solution pump
cover is not properly closed. Close the cover properly.
Clothes are caught in the
door.
Stop the programme, remove
the item from the door.
Startthe programme again.
The emergency drain hose is
not properly fastened or is
loose.
Fasten the emergency drain
hose correctly (see “Carrying
out an emergency drain op-
eration”). If the emergency
drain hose is loose, contact
Customer Service.
Fabric softener is not
drawn in, the condi-
tioner æ compartment
is full of water.
The fabric softener tray in
the conditioner compart-
ment is not correctly posi-
tioned, or is clogged.
Clean the detergent dis-
penser drawer, set the fabric
softener tray firmly in posi-
tion.
Clothes are severely
crumpled.
Too much washing has
probablybeen loaded.
Note the maximum wash
load (see Programme tables).
For easy-care textiles, select
the EASY IRON (STRIJKVRIJ,
SANS REPASSAGE) pro-
gramme.
Washing is not spun
sufficiently, excess wa-
ter is still visible inthe
drum.
Error code E20 ap-
pears. The RINSE (SPOE-
LEN, RINCAGE)
indicator flashes.
There is a kink in the outlet
hose. Straighten the hose.
The maximum pump height
(outlet hose height 1m from
from the support surface of
the appliance) has been
exceeded.
Call Customer Service, who
have modification kits avail-
able as accessories for pump
heights over 1m.
The detergent solution pump
is clogged.
Switch off the appliance and
pull out the mains plug.
At the syphon coupling:
Thesyphon is clogged . Clean the syphon.
Fault Possible Ca use Remedy