Electrolux EI28BS65KS, 242183201 manual Cabinet Leveling & Refrigerator Door Alignment if necessary

		Installation	7
Freezer Drawer Alignment (if necessary)		To level the cabinet using the front rollers:
		1 Slightly open freezer drawer. Lift the toe grille and
1	Check gasket seal around top, bottom, and sides
		gently pull forward (see illustration).
	of freezer drawer.
		2 You can raise or lower each door. Use a 3/8 inch
2	If gasket is not sealed, open drawer and slightly
		socket wrench to turn the adjustment screws (1
	loosen four (4) drawer screws (two (2) on each
		per side).
	side) to allow drawer to rotate.
3 Close drawer and recheck the seal on the gasket
	(A). Open the drawer grabbing by the sides in the
	center (B). Be careful not to rotate the drawer.

			To raise: turn adjustment screw clockwise.
			To lower: turn adjustment screw counterclockwise.
		3	Ensure both doors are bind-free with their seals
			touching the cabinet on all four sides and that
4	Tighten four (4) drawer screws.		cabinet is stable.
		4	After unit is leveled, lower anti-tip leg until it
5	Recheck gasket seal.
			contacts the floor.

Push Against Freezer Drawer

A

B

Grab Drawer

At Center

From Both Sides

Then

Pull Drawer Out

Door	Door
	Raise

Cabinet Leveling & Refrigerator Door Alignment (if necessary)

Guidelines for final positioning of your refrigerator:

•All four corners of the cabinet must rest firmly on the floor.

•The sides should tilt 1/4 inch (6 mm) from front to back (to ensure that doors close and seal properly).

•Doors should align with each other and be level.

Most of these conditions can be met by raising or lowering the adjustable front rollers.

Anti-tip

Leg

Lower

5Install the toe grille by fitting into place.