Electrolux 36 manual LED Messages or Light Indicators Displayed by Main Control

Setting Surface Controls 11

LED MESSAGES OR LIGHT INDICATORS DISPLAYED BY MAIN CONTROL

CONTROLS LOCK - This feature allows the cooktop to be locked at anytime. Touch and hold the LOCK key pad for few seconds. If the cooktop is in use, it will be impossible to enter in the lock mode. All elements need to be turned OFF. When entering in the lock mode, a beep will sound and the Lock Indicator Light will glow (Fig. 2). Once locked, no other displays will glow and no Cooking Zones will activate, but the Minute Timer Feature will be available. To turn the Controls Lock OFF, touch and hold the LOCK key pad for few seconds. A beep will sound, the Lock indicator light will turn OFF (Fig. 1) and the cooktop may be used normally.

COOKTOP POWER - The Cooktop POWER key pad activates the entire Cooktop. To power the cooktop, touch and hold the POWER key pad. A beep will sound and the Power LED will glow (See Fig. 4). The cooktop will be in a ready mode. If no other key pads are touched the Cooktop Main POWER will turn OFF automatically. To turn the Main Power OFF touch and hold the Main POWER key pad. A beep will sound and the Power Indicator Light will turn OFF (See Fig. 3).

ERRORS CODES XX - The Minute Timer display digits showing an error code. “E -” (Fig. 5) and a two digit number error code (Fig. 6) will flash in turn in the Minute Timer display.

lock

Fig. 1

POWER

Fig. 3

Fig. 5

lock

Fig. 2

POWER

Fig. 4

Fig. 6

LIGHTINDICATORSDISPLAYEDBYCOOKINGELEMENT CONTROLS

COOKING ZONE ON/OFF PAD - Each Cooking Elements have separate ON/OFF key pads. Once the Main Power key pad has been touched to activate the cooktop, touch the corresponding Cooking Element ON/OFF key pad once to active the Cooking Zone needed. The indicator light located above the key pad will glow (Fig. 8). If the correspond- ing hi + (increase), med or - lo (decrease) key pad is not touched, the request to turn the Cooking Element ON will cancel and the Cooktop Main Power will turn OFF. To set a Cooking Element power level touch the corresponding Cooking Element hi + (increase), med or - lo (decrease) key pad once. To turn OFF a Cooking Element, touch the Cooking Element ON/OFF key pad once. The Cooking Element Indicator Light will turn OFF (Fig. 7).

HOT SURFACE INDICATOR LIGHT - After using any of the single, dual or triple radiant element positions the cooktop will become very hot. Even after turning the control to OFF, the cooktop will remain hot for some time. The hot surface indicator light will turn on (Fig. 9) if the cooktop is still hot and will remain on until the heating surface area has cooled sufficiently. If the indicator light is on, the control can still be turned ON again for use.

ON OFF	ON OFF
Fig. 7	Fig. 8

hot surface

Fig. 9