Electrolux 50610 manual programme running. If you have inadvertently started a programme

	Operating Instructions
1	It is only possible to adjust the water hardness setting when there is no
	programme running. If you have inadvertently started a programme

(an LED indicator is constantly illuminated), then the programme must be cancelled by pressing the appropriate button.

1.The appliance must be switched off.

2.Press the water-softener and function buttons simultaneously and keep them pressed.

3.In addition press the ON/OFF button.

4.The LED indicator for the water-softener button flashes.

5.Press the water-softener button again.

–The LED indicator for the water-softener button will be continuously illuminated for an initial 5 seconds and then begin to flash.

–The number of flashes corresponds to the hardness setting.

–The sequence of flashes is repeated several times after a 5 second pause.

6.Each time you press the water-softener button the hardness setting will go up by 1.

(Exception: Hardness setting 1 follows hardness setting 5).

–If the hardness setting is changed, the LED indicator for the water- softener button will confirm the change by remaining illuminated continuously for 5 seconds and then flashing again.

–The number of flashes corresponds to the new hardness setting.

–The sequence of flashes is repeated several times after a 5 second pause.

7.Once the hardness setting is correct, press the ON/OFF switch. The hardness setting is then saved.

11