| Operating Instructions |
| Pause function |
3 | The pause function can only be initiated before the drying section of |
| the programme I.. If the pause function is initiated during the drying |
section of the programme I the wash programme is ended.
Using the pause function the dishwasher can be temporarily stopped: 0 1. Press the ON/OFF button. The wash programme will stop.
2.All indicators will go out.
3.After a short time when the wash programme is to continue, press the ON/OFF button again. The wash programme will continue.
2 | The wash programme should not be stopped for a prolonged period or |
| the cooled water will need to be reheated resulting in increased energy |
consumption.
Setting or changing the delay start timer
Using the delay start timer you can opt to set the wash programme to start in 3, 6 or 9 hours.
0 1. Press the ON/OFF button M.
2.Setting the delay start timer:
Press the b button until the indicator next to the number of hours of delay illuminates.
Changing the delay start timer:
As long as the wash programme has not started, you can still change the delay start set by pressing the b button. Repeatedly press the b button until all three of the time indicators are off. The selected wash programme will begin immediately.
3.Press the button for the required wash programme. The programme indicator lights up.
4.After the set number of hours the wash programme will begin.
Load Sensing – Sensor Logic
If a wash programme is started even though there are only a few dishes in the upper and/or lower rack, an intelligent electronic system adjusts the amount of water and the duration of the wash programme to the number of dishes. By this means it is possible to wash only a few dishes quickly and economically. At half load (6 place settings), up to 2 litres of water and 0.2 kWh of electricity are saved.
27
