Operating instructions
3.Fill with rinse aid, up to the broken line (maximum); this line corresponds to a quantity of approx. 150 ml
4.Replace the lid and tighten by turn- ing clockwise.
5.If rinse aid has been spilt, wipe up with a cloth. Otherwise there will be foaming during the washing.
| x | 6 | 5 | 4 |
|
| |||
m | a |
|
| |
|
| 3 | ||
|
|
| ||
|
|
| 2 | |
|
|
|
| 1 |
| Adjusting Rinse Aid Dosing |
3 | The dose should be adjusted according to the finish and drying results |
| obtained. The dose is factory set at 4, and can adjusted from 1 to 6. |
Gradually increase the dose if there are drops of water or lime spots on the dishes after washing. Reduce if it there are sticky whitish streaks on the dishes.
0 1. Turn the lid of the container ¼ of a turn anticlockwise and
remove.
2. Adjust the dose setting with a tea spoon.
3. Replace the lid and tighten by turn- ing clockwise.
4.If rinse aid has run out, wipe up with
a cloth.
In Daily Use
•Check the salt and rinse aid levels.
•Load cutlery and dishes into the dishwasher
•Fill with dishwasher detergent
•Select a wash programme suitable for the cutlery and dishes
•Start the wash programme
13
