Electrolux 50870 user manual Appears in the digital display

30Something not working

Fault code and malfunction		Possible cause and solution
appears in the digital display.	•	The water tap is blocked or furred with lime-
The dishwasher does not fill with water.		scale.
		Clean the water tap.
	• The water tap is turned off. Turn the water tap
		on.
	• The filter (where present) in the threaded hose
		fitting at the water inlet valve is blocked.
		Clean the filter in the threaded hose.
	•	The water inlet hose has not been correctly
		laid or it is bent or squashed.
		Check the water drain hose connection.
appears in the digital display.	•	The sink spigot is blocked.
The dishwasher will not drain.		Clean out the sink spigot.
	•	The water drain hose has not been correctly
		laid or it is bent or squashed.
		Check the water drain hose connection.
appears in the digital display.	•	Close the water tap and contact your local
Anti-flood device is activated.		Service Force Centre.
The programme does not start.	•	The dishwasher’s door has not been properly
		closed. Close the door.
	•	The main plug is not plugged in. Insert the
		main plug.
	•	The fuse has blown out in the household fuse
		box.
		Replace the fuse.
	•	Delay start has been set.
		If dishes are to be washed immediately, cancel
		the delay start.

Once these checks have been carried out, switch on the appliance: the programme will continue from the point at which it was interrupted.

If the malfunction or fault code reappears contact the Service Force Centre.

For other fault codes not described in the above chart, please contact your local Service Force Centre, quoting the model (Mod.), product number (PNC) and serial number (S.N.).

This information can be found on the rating plate located on the side of the dishwasher door.