Problem

Possible cause

Remedy

 

 

Select a different programme

 

Wrong programme selected.

the next time you dry (see

 

 

“Overview of programmes”

 

 

section).

 

Lint filter clogged.

Clean lint filter.

Drying results unsatis-

Heat exchanger clogged

Clean heat exchanger.

with lint.

 

factory.

 

Observe recommended load-

 

Incorrect volume of laundry.

 

 

ing volumes.

 

Ventilation slots in base area

Uncover ventilation slots in

 

covered up.

base area.

 

Residue on inside surface of

Clean inside surface of drum

 

drum or drum ribs.

and drum ribs.

Loading door does not

Fine strainer not in place

Install fine strainer and/or

and/or large mesh filter not

snap large mesh filter into

close.

locked in place.

place.

 

When pressing the

Washing protection. After

Turn the programme knob to

& SPECIAL CARE but-

the start of the programme,

ton, the corresponding

the option can no longer be

O OFF. Set the programme

indicator flashes sever-

set.

again.

al times.

 

 

Programme inactive,

Condensate tank is full.

Empty condensate tank, then

o EMPTY WATER dis-

start programme with

play illuminated.

 

START/PAUSE button.

Drying cycle ends

Not enough washing load-

Select time programme or

shortly after pro-

higher drying level (e.g.

ed or washing loaded is too

gramme starts. E END

N INTENSIVE DRY instead of

display illuminated.

dry for selected programme.

» STORAGE DRY).

 

 

Lint filter clogged.

Clean lint filter.

Drying cycle lasts an

Heat exchanger clogged

Clean heat exchanger.

unusually long time.

with lint.

 

Note:

& SPECIAL CARE button

& SPECIAL CARE is only suita-

After around 5 hours

pressed and load volume too

ble for use with loads of up to

the drying cycle ends

big.

2,5kg!

automatically (see

 

 

„Drying cycle com-

Load volume too big.

Reduce load volume.

plete“).

 

 

Laundry insufficiently pre-

Laundry must be adequately

 

 

drained.

pre-drained.

 

 

 

20