Changing the bulb for interior lighting | Electrolux 58840R specs

What to do if ... 33

Changing the bulb for interior lighting

Only use a special bulb which is designed specially for dryers. The special bulb can be obtained from the Customer Care Department, ET no. 112 552 000-5.

When the appliance is switched on, the interior lighting switches itself off after 4 minutes when the door is open.

WARNING!

Do not use standard bulbs! These develop too much heat and may damage the machine!

WARNING!

Before replacing the bulb, disconnect the mains plug.

1.Unscrew cover above the bulb (this can be found directly behind the loading aperture, at the top; refer to “Description of machine” section.)

2.Replace defective bulb.

3.Screw cover back down.

Check the correct positioning of o-ring gasket before screwing back the door light cover. Do not operate the dryer when missing o-ring gasket on door light cover.

WARNING!

For safety reasons, the cover must be screwed down tightly. If this is not done, the dryer must not be operated.

Image 33

Electrolux 58840R user manual Changing the bulb for interior lighting, Replace defective bulb Screw cover back down

Contents

Lavatherm 58840R Dear Customer Contents Service General safety Important safety information Installation Use Child safety Product description Control panel Before first use What is shown in the displaySorting and preparing laundry Sorting laundry Preparing laundry RPMT/MIN Programme overview Lichte Strijken WOL Daily use Switching machine on / switching light onOpening loading door / loading laundry Selecting the programme Setting the pre-drainage spin speed Setting dryness levelSelecting additional options If the washing in the washing machine was For especially gentle drying of sensitive fab Delicate When the option is active, the Sensitive icon is on Long anti-crease phase lengthen the anti Setting delay timer Setting child lockTime Changing programme Starting the programme Drying cycle complete / removing laundry Open doorClose the door Drying rack Min, from 30 min. up to 180 minutes Care and cleaning Cleaning fluff filterAfter cleaning do not forget to put it back Clean the entire filter area Cleaning the door seal Emptying the condensate tankEmpty condensate tank after every drying cycle Drying cycle Cleaning heat exchanger Care and cleaning Turn both lock washers inwards Cleaning the drum Clean operating screen and housing What to do if Troubleshooting by yourself Start Pauze button Replace defective bulb Screw cover back down Changing the bulb for interior lighting Setting Implementation Buzzer permanent off Machine settings Consumption values Technical data Hints for test institutes InstallationAppliance positioning Cotton cycle with nominal and half load Drying rack unpacking Removing transport safety packaging Changing door stop Electrical connectionRemove the elastic band fixing the rack handle to container For easiest unpacking turn the rack upside downPage Intermediate installation kit for stacked washer and dryer Special accessories Environment Packaging materialOld appliance Pre-draining Drying cycle Environmental tips Service Subject to change without notice