
34 Machine settings
Machine settings
Setting |
|
|
| Implementation | |
BUZZER permanent off | 1. | Turn the programme selector to any programme. | |||
| 2. | Press simultaneously the DRYNESS DROOGTEGRAAD and | |||
|
| RPM T/MIN buttons and hold down for approx. 5 seconds. | |||
| 3. | The buzzer is by default always off. You can use BUZZER | |||
|
| option to activate or deactivate sound but machine does | |||
|
| not memorize your selection. |
| ||
|
|
| |||
Water hardness | 1. | Turn the programme selector to any programme. | |||
Water contains, a variable quantity | 2. | Press simultaneously the DRYNESS DROOGTEGRAAD and | |||
of limestone and mineral salts of |
| TIME TIJD PROGR. buttons and hold down for approx. 5 | |||
| seconds. The current setting is on the display: | ||||
which quantities vary according to |
| ||||
| – |
| low conductivity <300 micro S/cm | ||
geographical locations thus vary- |
|
| |||
ing its conductivity values. |
| – |
| medium conductivity | |
Relevant variations of the |
| – |
| high conductivity >600 micro S/cm | |
conductivity of the water compared | 3. | Press the START PAUSE START PAUZE button sequentially | |||
to those prefixed by the factory |
| until you set desired level. |
| ||
could slightly influence the residual |
|
| |||
4. | To memorize setting press simultaneously the DRYNESS | ||||
humidity of the laundry at the end |
| DROOGTEGRAAD and TIME TIJD PROGR. buttons or turn | |||
of the cycle. Your dryer allows you |
| ||||
| knob to OFF UIT position |
| |||
to regulate the sensitivity of the |
|
| |||
|
|
|
|
| |
drying sensor based on |
|
|
|
|
|
conductivity values of the water. |
|
|
|
|
|
Emptying water tank - warning | 1. | Turn the programme selector to any programme. | |||
message permanent off | 2. | Press simultaneously the RPM T/MIN and TIME TIJD | |||
When using an external drain for |
| PROGR. buttons and hold down for approx. 5 seconds. | |||
| The current setting is on the display: | ||||
the condensed water. |
| ||||
|
| – | warning | icon and | - warning message is |
|
|
| off |
|
|
|
| – | warning | icon and | - warning message is |
|
|
| switched on |
| |
| By default the warning message is switched on and displayed | ||||
| always at the end of the drying cycle or during the cycle if | ||||
| the water container is full. |
| |||
|
|
|
|
|
|